Support articles

Find clear, step-by-step solutions to common WithSecure issues across installation, configuration, updates, and product performance.

How to configure Elements Exposure Management to send email notifications when Discovery and Network (System) scans start and end?

Issue:

How to configure Elements Exposure Management to send email notifications when Discovery and Network (System) scans start and end? 

Resolution:

You can configure Elements Exposure Management to send email notifications to selected recipients. The emails can be sent when:

  • Scan starts
  • Scan starts or ends
  • Scan ends 

To change the email notification settings for Discovery Scans:

  1. Log in to the Elements Security Center
  2. Navigate to the Security configurations > Scans > Discovery scans page
  3. Click on the three dots on the right side of a discovery scan and select Edit scan settings 
  4. Go to the Other settings section
  5. Enable Notifications if it hasn't been enabled
  6. Select one of these options:
    1. Scan starts
    2. Scan starts or ends
    3. Scan ends 
  7. Click Save and close

 

To change the email notification settings for System Scans:

  1. Log in to the Elements Security Center
  2. Navigate to the Security configurations > Scans > Network scans page
  3. Click on the three dots on the right side of a scan group scan and select Edit scan group
  4. Go to the Notifications section
  5. Enable Notifications if it hasn't been enabled
  6. Select one of these options:
    1. Scan starts
    2. Scan starts or ends
    3. Scan ends 
  7. Click Next step
  8. Click Finish