Support articles
Find clear, step-by-step solutions to common WithSecure issues across installation, configuration, updates, and product performance.
Elements Exposure Management Network scan stuck at "Running" status for more than 24 hours
Last updated
Issue:
Elements Exposure Management Network scan (system scan) stuck at "Running" status for more than 24 hours
Resolution:
If you are using you own internal Elements Exposure Management Scan node and scans are stuck in "running" status for a very long time, we recommend to make sure that the scan node has enough processor (CPU) performance, memory (RAM) and disk space available.
Scanning multiple scan targets at a time is a very resource heavy task, so if scans take a long time, we recommend to check that the server is up to the task.
You can from the scan group settings adjust how many scan targets are scanned simultaneously. This can improve scan performance in cases where system resources are at their limit on a scan node server:
- Log in to the Elements Security Center portal
- Navigate to the Security configurations > Scans > Network scans page
- Click on the three dots for a scan group and click Edit scan group
- In the Group details section, modify the Max system scans value to a smaller amount.
To check if the issue is caused by a lack of resources, you can start a network scan for one scan target. If the network scan goes through faster on one scan target, then the issue is with the scan nodes resources.