Support articles

Find clear, step-by-step solutions to common WithSecure issues across installation, configuration, updates, and product performance.

How to collect installation trace logs for WithSecure Linux Protection and Linux Security 64

Issue:

Sometimes WithSecure Linux Protection or Linux Security 64 installation and/or activation fails and additional trace logging is required to determine the root cause. This document describes how to generate the trace logs while uninstalling and reinstalling the product on the affected system.
 

Resolution:

To generate the logfiles, use these instructions. Perform them as root or while using sudo

 
Remove Linux Protection completely 
 
  • RHEL-based distributions: rpm -e linuxsecurity-installer
  • Debian-based distributions: dpkg -r linuxsecurity-installer
  • rm -rf /opt/f-secure
  • rm -rf /etc/opt/f-secure
  • rm -rf /var/opt/f-secure
If the device is still visible in the Elements Security Center portal, remove the device from the portal as well.
 
Reinstall Linux Protection

  • RHEL-based distributions: rpm -Uvh linuxsecurity-installer.rpm 
  • Debian-based distributions: dpkg -i linuxsecurity-installer.deb 
Enable setup tracing

export FSECURE_TRACE_SETUP=.

 

Activate Linux Protection while capturing the trace output:
/opt/f-secure/linuxsecurity/bin/activate --psb --subscription-key <insert-your-key> id> 2>&1 | tee -a setup_trace.log

When the issue reproduces, share the following information via the support ticket.

  1. The file setup_trace.log created above
  2. Freshly created fsdiag file created by running /opt/f-secure/linuxsecurity/bin/fsdiag․sh
  3. output from the terminal used to reinstall the product (copy/paste this into a file or the email) showing the failed installation including errors.